Sony SLV-E580

Mauser · **Wysłany:** Czw Maj 31, 2007 6:39 pm

Mam takie pytanie. Jak uruchomić tryb serwisowy w tym magnetowidzie, i czy da się tam przeprowadzić test przełączania się głowic?

Elektronik

Igor-b · **Wysłany:** Sob Cze 02, 2007 6:05 pm

Mam taką serwisówkę, oto co piszą:

Cytuj:

SERVO SYSTEM Adjustment
RF Switching Position Adjustment
Purpose:
Adjust the interval between A ch and B ch of tape playback output.
Improve the interchangeability with other tapes and sets.
When it is out of order, the interval appears on the screen, the screen is disturbed.
Measurement Point : CH1: VIDEO LINE OUT, CH2: Pin 2 of CN261(RP-230 board) (RF SWP)
Adjusting Method:
1) Connect RP-230 board Pin 5 of CN261 to the GND for about 1 secont to activate the RF switching position adjustment mode.
2) Check appear “A P” on FL display.
3) Using the channel + and – buttons, adjust to 416 ± 32 µsec
(6.5 ± 0.5 H).
4) Press the pause button.
2-4. VIDEO SYSTEM ADJUSTMENT
Adjust the video system in the following sequence as a rule. The color video signal supplied from the pattern generator is used as a video input signal for video system adjustment in the recording mode.

Mauser · **Wysłany:** Sob Cze 02, 2007 10:17 pm

Igor-b napisał(a):

Mam taką serwisówkę, oto co piszą:

Cytuj:

SERVO SYSTEM Adjustment
RF Switching Position Adjustment
Purpose:
Adjust the interval between A ch and B ch of tape playback output.
Improve the interchangeability with other tapes and sets.
When it is out of order, the interval appears on the screen, the screen is disturbed.
Measurement Point : CH1: VIDEO LINE OUT, CH2: Pin 2 of CN261(RP-230 board) (RF SWP)
Adjusting Method:
1) Connect RP-230 board Pin 5 of CN261 to the GND for about 1 secont to activate the RF switching position adjustment mode.
2) Check appear “A P” on FL display.
3) Using the channel + and – buttons, adjust to 416 ± 32 µsec
(6.5 ± 0.5 H).
4) Press the pause button.
2-4. VIDEO SYSTEM ADJUSTMENT
Adjust the video system in the following sequence as a rule. The color video signal supplied from the pattern generator is used as a video input signal for video system adjustment in the recording mode.

Okay! fajnie widze,że jest servo adjustmant, ale jak się dostać do trybu serwisowego w tym magnetowidzie?

Zenek12 · **Wysłany:** Pon Cze 04, 2007 4:14 pm

Cytuj:

Connect RP-230 board Pin 5 of CN261 to the GND for about 1 secont to activate the RF switching position adjustment mode.

Z opisu wynika, że trzeba zewrzeć 5 pin CN261 złącza RP-230 do masy na 1 sekundę to przejdzie w tryb "adjustment mode"

Elektronika

Sony SLV-E580

Kto jest online